Now you should see that the Surveillance Station icon no longer grayed out. The default gateway should be the same as the LAN IP of your router, which is 192.168.2.1 in our example.Ģ – First go to “Applications -> QPKG Center” and install “Surveillance Station Pro” QPKG:ģ – Go to ‘ Applications‘ > ‘ Surveillance Station‘ and tick both checkboxes of ‘ Enable Surveillance Station‘ and ‘ Show service link on the login page‘ then click on ‘ Apply‘ button to save the settings. Note: The Surveillance Station Pro is only supported on Internet Explorer 6.0 or above.ġ – Go to ‘ System Administration‘ > ‘ Network‘ > ‘ TCP/IP‘ specify a fixed IP to the NAS: 192.168.2.91. You can then set the IP address and login the camera’s configuration page by the default login name and password ( root / pass). The camera settings will be restored to default. Press the reset button at the back of the camera for 5 to 10 seconds. Tip: What if I forget the camera settings? You will then be able to view the monitoring image.Ħ – GO to ‘Network -> General” and check the IP settings of the camera.ħ – Change Ip Adress configuration as you plan, and should be look like this: Lilin Camera Default Ip adress is 192.168.0.200, so type explorer this:ĥ – The first time you access the configuration page by the IE browser, remember to install the ActiveX control if asked. The default login name and password of Lilin camera is root / adminĤ – ENTER the web configuration page of the IP camera. Note: The default IP of Lilin Hybrid D/N 720P CMOS HD IP camera is 192.168.0.200 The default gateway should be set as the LAN IP of the router (192.168.2.1 in our example). Enter the IP address of the camera as 192.168.2.95. You will then be able to login the configuration page of the camera with the IE browser. I’ll use Lilin “Hybrid D/N 720P CMOS HD IP Camera / IPG012ESX” with Onvif Support at this Example:Ģ – TAKE out the CD-ROM from the camera package of your Lilin camera package and install the IP Finder Program.ģ – Set the IP address of the camera so that they are in the same LAN as the computer. In this example:ġ – Configure the IP address for both IP cameras by the following steps. Assign fixed IP addresses for the NAS and the IP cameras. Your computer, the NAS, and the IP cameras should be installed to the same router in LAN. The IP address of your router and the wireless SSID.Write down your plan of the home/office network before starting to set up the surveillance system. I – Plan Your Home/Office Network Topology III – Configure the Surveillance Station on the QNAP NAS

Info Success Warning All Error Sending request to server failed! QNAP Account All Products User not found User already exists.I – Plan your home/office network topology

Internet connection error, please try again later.

Qnap surveillance station 5.1 download